Below are field parameters for stop and (for PC*MILER|Streets users) street address validation. A stop can be a city/state pair separated by a comma, a ZIP code, a latitude/longitude point or (with optional add-on modules) a Canadian Postal code or SPLC (Standard Position Location Codes). PC*MILER|Streets users may include street addresses.
For Cities with multiple ZIP codes, the first city in the returned list is the central city or default ZIP for that city, with the remaining ZIP codes returned in numeric order.
When generating potential matches for an address, PC*MILER|Streets does a “Grid Based” search. This means that the search area may extend beyond the city limits of the requested city for potential matches. You may receive back potential matches in a surrounding town. Pick lists are sorted in confidence order, with the “best” potential match returned first.
For example
Requesting a pick list by setting REQ-CIT equal to Princeton,NJ;Linden* would return the following list:
08540 Princeton, NJ, Mercer; 1 Linden Lane
08540 Princeton, NJ, Mercer; 49 Linden Lane
08540 Princeton, NJ, Mercer; 80 Linden Lane
08540 Princeton, NJ, Mercer; 100 Linden Lane
08534 Pennington, NJ, Mercer; Linden & Woodmer
08534 Pennington, NJ, Mercer; Linden & Woodmer
08822 Flemington, NJ, Mercer; 1 Linden Court
08822 Flemington, NJ, Mercer; 1 Linden Court
08536 Plainsboro, NJ, Mercer; 2 Linden Lane
08536 Plainsboro, NJ, Mercer; 3 Linden Lane
08536 Plainsboro, NJ, Mercer; 4 Linden Lane
TIP: Grid Based searches are only done with address level lookups (PC*MILER|Streets only).
Validation requests are important because error reporting in mileage requests is limited to the first two stops of a trip. If your bad stop is lower in the list of stops, you will not be told which is the non-valid stop; you will get a generic “Can’t Run Trip” message. The VA request type can be used to produce lists of potential matches to partial spellings or ZIP codes.
Validation Request
Validation Response
